I shall personalise my tipper - 55 JPM ORIGINAL

BODYWORK

• Tipper platform in high quality aluminium sheet: 5083 H16 thickness 3.5 mm
• Side members in extruded box-sections, thickness 3 mm, height 120 or 140 mm (depending on length) and outer frames in box-sections, thickness 3.5 mm, under the load surface
• Sideboards in extruded aluminium profile, height 400 mm (385 mm interior), double wall top and bottom, thickness 2.8mm, single wall, thickness 3.5 mm in the centre, fold-down, removable, interchangeable (right/left)
• Locking handle incorporated into the thickness of the sideboards
• Front face, interior usable height 450 mm, double wall top and bottom, thickness 2.6 mm, single wall, thickness 3.5 mm in the centre
• Cab Protect with aluminium grille diameter 5 mm with frame in extruded profiles, removable and without top cap
• Aluminium rear door, height 450 mm, double wall top and bottom, thickness 2.8 mm, single wall, thickness 3.5 mm in
the centre, automatic opening by cam of 15° (doorway 520 mm)
• Rubber opening stops on sideboards and rear door
• Rear pillars in galvanised steel, thickness 3 mm, removable, with 12 mm tightening fixing bolt and conical fitting
• Polypropylene fender flares with supports in unwrought aluminium
• Approved aluminium side protection, black powder paint
• Nickel Zinc treated bolts (5 times more resistant than standard galvanising)
• Tipping shaft without lubrication
• Outer frame adapted to lashing
• Short dumping overhang: 250 mm

SUBFRAME

• Aluminium profile tipper, thickness 4.5 to 12 mm
• Tipping by 3 or 4 expansion CYLINDER depending on length (no overhang under the subframe)
• 46° rear tipping angle
• Electrically driven pump unit, 12 or 24 volts depending on the vehicle
• 7-litre tank
• Hydraulic pressure 180 bars
• Wired remote control in cab

SAFETY

• Safety solenoid valve on cylinder
• Circuit breaker
• Safety stand
• Double safety device on the sideboard handles
• Double safety device on the upper door hinges

FINISH